PDA

View Full Version : Stinger III


  1. Stinger III is getting close to a ship date
  2. foot print
  3. Password and PostP questions
  4. zero bit
  5. squaring the gantry
  6. Machine quit running
  7. Z-Axis Linkage Clicking
  8. Basic start up procedure
  9. .5" plywood
  10. 514 in/min
  11. Spindle speed control
  12. stinger bling
  13. Stinger III footprint and door size
  14. Overall height of Stinger III w/ 2" gantry lift
  15. foot print vs. spec. drawing
  16. My Stinger III is here !!
  17. Ductwork Up
  18. Stinger III shipping soon!
  19. Machine quits running
  20. New Stinger III is in, what's next?
  21. Needs help
  22. Warm Up/Changing Spindel Speed
  23. Stinger III Order
  24. Changing router speed
  25. Plunge Rate
  26. Z cuts too deep.
  27. 3.5hp Milwaukee Router
  28. X3?
  29. Help Needed - Measure Tool Stopped Working
  30. HSD Spindle no start
  31. Spoil Board Question
  32. Replacement Power Switch & FTC pad?
  33. Hot Y-Axis Motors
  34. No activity in motors
  35. Stinger III - Greasing Hiwin HG20 Bearings
  36. Foot size on the stinger 3 leg.
  37. Stinger 3 servo motor option
  38. Support for used machines
  39. Hauling a Stinger III
  40. 3D Model Finish pass starts ok but bit wanders to Z+
  41. Hurricane Vacuum
  42. Vacuum table design
  43. Manually Z each tool x3
  44. Z Fuse Blowing