Tiling or pull through

[Hanson]

My name is Todd Hanson. I have a 48x48 Stinger II. I have three parts that are 15"x51" and when tiling on my 48" table on the Y, I'm leaving 4" on the table. I have tried to tile at 4" at 00, but then the machine runs it 4" all the way up the table. How do I get it to just cut the 4" and not tile all the way up? Ultimately, I would like to cut the 4" first, slide it forward and then cut the remaining. Does anyone have some suggestions?

[Mick Martin]

Hi Todd,

I have never done any tiling but why not made two tiles 25.5" long, this way you can start where you want to.
Check out this post on the Vectric forum it might help you viewtopic.php?f=2&t=11135&p=77666#p77666

You can also watch a Vectric video tutorial regarding tiling http://www.vectric.org/video/aspire3/2d_mach/b12-tile-toolpaths-web/12-tile-toolpaths-web.html