GJMATHEWS
07-02-2009, 04:28 PM
A customer sent me a photo of a corbel and asked me if I could reproduce it proportionately in size to a length of 19 inches. I said, "Of course I can!"
2 days later the corbel arrived and I reproduced it for them. CAD Time was less then 2 hours.
5 Corbels in paint grade maple on the CAMaster 4th Axis.
Machine cycle time is 1 hour 38 minutes each with 2 hours of finishing prior to shipping.
What is the difference between the little engine and the big engine?
The little engine says, "I think I can, I think I can!"
The big engine says, "I know I can!
At 19 inches in length, it is safe to say these are manly corbels!
2 days later the corbel arrived and I reproduced it for them. CAD Time was less then 2 hours.
5 Corbels in paint grade maple on the CAMaster 4th Axis.
Machine cycle time is 1 hour 38 minutes each with 2 hours of finishing prior to shipping.
What is the difference between the little engine and the big engine?
The little engine says, "I think I can, I think I can!"
The big engine says, "I know I can!
At 19 inches in length, it is safe to say these are manly corbels!