ready for 3d

[james mcgrew]

here is recent file of sail boat (Vectorart 3d) 1/8" taper bit from onsrud, cut 3d file into vcarve pro, 10% stepover, file is 12" tall by 21" wide set .625 deep,

material is 1" thick yellow heart, light 180 grit sanding, one coat of laquer

installed sign to follow

jim

[woodman08]

Jim
That looks great how much maching time and what 2 bits did you use
stan

[james mcgrew]

took about 1 hour and 50 minutes, 1/8 taper ballnose for carve ans 1.4 endmill for rough. see you in the am

jim

[Myshadowboxes]

Well, here is my first attempt at 3D. Jim you da man... Josh you could be a close second

2 Hours on the CNC (50 mins rough cut using 1/4 end mill bit and then 1 hour 10 mins using a 1/8" taper ball nose) about 30 mins to sand, stain and varnish

Anthony

[james mcgrew]

EXCELLENT!!!

post that on vectrics forum as well!!

[james mcgrew]

anthony, i cannot and did not do this with out josh joey paul and bill it take the whole team and now you are here with us!!

jim

[james mcgrew]

large piece i will video more

http://www.youtube.com/watch?v=4d8ps0HqTWQ

[james mcgrew]

two large pieces being installed, more later

[james mcgrew]

we have a large project in which aspire, the camaster routers and cpp are being used extensivly, here are some columns that will be used in a vanity in a moorish detail bath.

jim

[james mcgrew]

used aspire to do a two rail sweep and add the verticle flourish

jim

[TomM]

Hey Jim,
How long did it take to machine that? Looks like sign foam, but which density?

[james mcgrew]

15 # duna board hdu, took about 45 min

jim

[james mcgrew]

saw it today after the guys installed it now comes the burl doors

jim