Announcement

Collapse
No announcement yet.

2013 Cobra 510 Vacuum Gate

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • james mcgrew
    replied
    Check and see that the slide area of the gate is not caked with dust preventing full closure

    Leave a comment:


  • TimPa
    replied
    not familiar with "controlled or powered gates", mine are manual. but are you sure that you don't open the gate to allow vac to pass to the table, and close it to stop it?

    Leave a comment:


  • RickCNC
    replied
    It is not. I click the gate button on WinCNC to activate it on or off

    Leave a comment:


  • james mcgrew
    replied
    The gate is the culprit , is it an automatic ?

    Leave a comment:


  • RickCNC
    started a topic 2013 Cobra 510 Vacuum Gate

    2013 Cobra 510 Vacuum Gate

    Hi all,

    I recently started working for a new company and I'm running a 2013 Cobra 510.
    When I leave the vacuum pump running and open the gate to release the vacuum It's still drawing
    suction through the table. Granted, it's not enough to prevent me from removing
    the parts from the table but it's enough to where I can't slide a new sheet of material
    freely on the spoilboard.

    Has anyone else encountered this and if so what was your work around or fix for this issue?

    Thanks,
    Rick
Working...
X