Announcement

Collapse
No announcement yet.

Spindle ignoring speeds set by software

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts
  • Spindle ignoring speeds set by software


    I submitted a ticket monday, but while I am waiting to hear back from tech support, I thought some of you out there might have some troubleshooting ideas. I'm not sure where to start.

    Wincnc displays the appropriate speed as set by the .tap file.
    But the 5hp spindle just runs up to 24000 rpm (as shown on the VFD display.)
    It does it on warmup too. So I'm thinking the VFD isn't getting proper information from a piece of hardware?

    Thanks for any input.
    Zach
    2022 Panther 510 ATC
    Aspire
    Last edited by ZConsorti; 08-10-2022, 02:09 PM.
    2022 510 Panther ATC
    Aspire
  • #2

    Working with Camaster on it right now.
    2022 510 Panther ATC
    Aspire

    Comment

    Working...
    X