Where to learn how to get started...

[scubanimal]

Hello,
After reading about what happens if its done wrong, and seeing next to nothing in the Stinger Manual regarding the Recoil I was wondering if there is a "how to" set up and getting started using the Recoil. I think I have my Aspire file set up fine, and have my material center as the z0. But I don't know how to set z0 on my Stinger1 and need some other basic startup info. Just not finding it.

Can anyone point me to some good start up docs I can read?

Thank you,
Ian

[drummerjg]

Ian,
I highly recommend Gary Campbells one on one rotary lathe class. Its done over the phone with a nice Power Point slide show. Gary does an excellent job in getting you off the ground to use the lathe. Well worth the time. Send him a message to get more info....you won't regret it.

[Davemartin88]

I would second the recommendation for Gary’s rotary class, well worth the expense!

[mike.davison]

In addition to Gary's training, there are several CAMaster-specific videos on YouTube that provide some tips for using the rotary axis. Mick Martain, has one that walks through setup, for example.

I learned from the YouTube videos, but would have saved time and money by taking Gary's training (didn't know about it at the time).

[Bigshaw929]

Is Gary still doing this one in one training? I’ve had my rotary sitting in my shop for almost 2 years now. I just had shoulder surgery so with everything coming to a stop figured it’s about time for me to get off my butt and finally do some learning.

[keithrhyde]

Ditto from me on Gary's recoil class definitely worth every penny.

[B80Designs]

Is Gary still doing this one in one training? I’ve had my rotary sitting in my shop for almost 2 years now. I just had shoulder surgery so with everything coming to a stop figured it’s about time for me to get off my butt and finally do some learning.

Seeing if this is through CAMaster or something external. Thanks!

[Hummingbird]

I reached out to Gary Campbell.. he is no longer offering a class. Other suggestions?

[keithrhyde]

I can send you his powerpoint slides that he uses in the class but I need to check with him first since he asks me not to share. YouTube videos are great. I have two monitors so I can bring the video up on one and follow along on the other so if I miss something I can wind back. I tried split screen but unless you have a thirty inch it is too hard IMHO. Send me your email address to hyde.consulting@comcast.net so I can send you the PowerPoints if Gary gives the OK.

[Cdarby67]

Keith,

if Gary was/is ok with it - I too would like the slide presentation.
I sure wish that Gary was doing one-on-one still. I have so many questions.

Thanks,

Clint

[keithrhyde]

Clint, send me an email.

[Seaweed81]

Sent you an email Keith if you are able to share. Thanks

[Cdarby67]

Sent.

thanks,
Clint