Good morning all -
My Stinger 1 has been in storage for a couple of years now .. finally got a nice outbuilding at the new house now to put it in ... therefore I am kind of starting from scratch again getting this thing set up ...
So with this stinger, the spoilboard is obviously longer than the 48 inch travel of the gantry ... so therefore I set my X0 Y0 at the top right ... but when I set the XY Datum Position in Aspire to the upper right and export toolpaths, it gives me negative X/Y coordinates in the GCode ... which of course then errors out in WinCNC ...
Thoughts?
Thanks in advance
Don
Screenshot 2026-10-27 085736.png
My Stinger 1 has been in storage for a couple of years now .. finally got a nice outbuilding at the new house now to put it in ... therefore I am kind of starting from scratch again getting this thing set up ...
So with this stinger, the spoilboard is obviously longer than the 48 inch travel of the gantry ... so therefore I set my X0 Y0 at the top right ... but when I set the XY Datum Position in Aspire to the upper right and export toolpaths, it gives me negative X/Y coordinates in the GCode ... which of course then errors out in WinCNC ...
Thoughts?
Thanks in advance
Don
Screenshot 2026-10-27 085736.png
Comment