When we are running a job we design in Fusion 360 and send to our Stinger 1, it has a part of the file that is extremely slow going around a curved section to be cut out. Lots of back and forth moves of G1, G2 File should cut faster than that. the whole file takes 2:23 to run. About 1:20 of that is cutting two arc areas out.
When looking at my WINCNC INI file it has a section called AUTOARC F20 on it.
The file was programed to run at 145 ipm. Cutting 0.080" boltaron plastic. Anybody have an idea how to adjust or fix this. DJ from Tech support is involved at this point. I sent then some video of the section of code going across the screen while running.
Thanks
Todd
When looking at my WINCNC INI file it has a section called AUTOARC F20 on it.
The file was programed to run at 145 ipm. Cutting 0.080" boltaron plastic. Anybody have an idea how to adjust or fix this. DJ from Tech support is involved at this point. I sent then some video of the section of code going across the screen while running.
Thanks
Todd
Comment