CAMheads CNC Router Forum By: CAMaster CNC

Go Back   CAMheads CNC Router Forum By: CAMaster CNC > Members List

Bmay8683 Bmay8683 is offline

CAMhead Guest

Visitor Messages

Showing Visitor Messages 1 to 1 of 1
  1. Bmay8683
    04-09-2020 01:39 PM
    Bmay8683
    Each time I use the 1.5" spoiler board clearing bit for the flat panel shutters we make the bit leaves one very noticeable path on the right side which is the last pass. We use Extira which is a exterior MDF. The spindle feed is 14000 feed rate is 175 per inches per minute. I've tried measuring the tool each time. It doesn't matter where the last pass is it leaves the pestering line. It's only maybe a 64th or so difference but it's very noticeable. I would post a photo but can't figure it out on my phone. Any help will be greatly appreciated.
    Thanks
    Barry

About Me

  • About Bmay8683
    Biography
    Making custom exterior shutters
    Location
    Greenville SC
    Interests
    Anything involving wood working

Statistics

Total Posts
Visitor Messages
General Information
  • Last Activity: 05-09-2020 05:52 PM
  • Join Date: 08-23-2017
  • Referrals: 0

All times are GMT -4. The time now is 11:39 PM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.