
Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
EEEkk!!!! It worked!!!!
-
Thank you. I'll try that. And I actually have a seperate spindle on/off switch. I turn the machine on and then turn the spindle on. So I'm assuming that...
Leave a comment:
-
what tool would i select for the toolpath? I can open the cutknofe gadget but dont see any kind of tool that looks like i should choose? Anything ive...
Leave a comment:
-
Nevermind. I figured it out as far as the processor.
Now to the toolpath. Am I correct that it has to be drawn and created for the drag...Last edited by camchic; Today, 08:07 AM.
Leave a comment:
-
So when I go into that folder the only thing in there is a Readme file that says if u place any Post processors there "they will become the *only*...
Leave a comment:
-
Post Processor Help Needed
I am trying to add my cut knife tool, which apparently I have to first add a post processor to my list. It should be a simple 8 steps. I can't get past...
-
Wincnc.ini EMPTY
So I not been able to figure out how to get he machine to run the full area. I found an awesome document that explains how to go into the .ini file and...You do not have permission to view this gallery.
This gallery has 1 photos.
-
I got a fairly cheap laser engraver/cutter to learn the bare basics (x, y, center, measuring, etc) Of course this is a completely different ball game...You do not have permission to view this gallery.
This gallery has 2 photos.
Leave a comment:
-
We got it going! We got the spoilboard flat. And are getting ready to cut out first scrap peice of why we even bought the machine. Thank you. It's awesome...
Leave a comment:
-
Omg!!!!!! Thank you! I've been googling the question and following the link from there to here. ????????...
Leave a comment:
-
Sorry. It took me a minute to be able to get to the shop....You do not have permission to view this gallery.
This gallery has 2 photos.
Leave a comment:
-
Nevermind that I tried to delete it but thats for vcarve. I'll check the other....
Leave a comment:
-
I just happened to take a picture of that area a couple days ago to see if I could find any helpful information....You do not have permission to view this gallery.
This gallery has 1 photos.
Leave a comment:
-
Search Feature
Sorry for thr newb question but I've searched everywhere for a search feature. Is there one? If so, where? Thanks!
-
CAMaster Retro
If I wanted to find a user manual for my old guy what version would I look for? The virtualcc program or wincc has a cobra on it. Is that what inwould...You do not have permission to view this gallery.
This gallery has 1 photos.
-
It's an old old Camaster (pictures in OP) and the program is vcarve pro. These pictures so how far the x is going and you can see how much the spoilboard...You do not have permission to view this gallery.
This gallery has 2 photos.
Leave a comment:
-
I'm not sure where the best place to post a question about the perimeter of where the router runs. It seems like the x axis isn't going over as far as...
Leave a comment:
-
Ok so apparently it has vcarve on it already. So it's just learning the actual router now....
Leave a comment:
-
Where is the best place to start as far as tutorials or the best reads? Best software? I used lightburn with the laser but I don't think it's beast enough...
Leave a comment:
-
We've worked with a couple different plasma tables over the years and this is by far the best built machine we've seen. Especially after learning it's...
Leave a comment:
No activity results to display
Show More
Leave a comment: