sam123
CAMhead Friend
Last Activity: Yesterday, 10:21 AM
Joined: 09-22-2022
Location:
-
I did escape key and than red panic button. This is my wincnc screen... -
abort.mac
I was surfacing the spoil board and have to stop the program because dust boot fibers were breaking up, Now today cant start spindle and message is "returning... -
levelling machine
Do you need to level machine and then put soil board and resurface? or just resurfacing soil board will be enough. My mache is on stems and not perfectly... -
Servo motor replacment
Got new stinger II. Servo motor defective. Got replacement motor. I hired a certified electrician but we can not find the motor screw which is last step...Last edited by sam123; 05-11-2023, 10:57 PM.
No activity results to display
Leave a comment: