Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
-
-
A touch probe if you mean the ones used in older 3d scanning IMOP are obsolete and Slooooowwwww to boot. I presume this is the touch probe you are referring...
Leave a comment:
-
Not to be over simplified, I have a CAMaster Cobra built in 2012 and runs daily cutting volumes of work, My machine is left on at all Times and has been...
Leave a comment:
-
Welcome.aboard. you have found a great machine and an awful lot.of good teachers here
Leave a comment:
-
I have cut thin metal laminates with the cnc, not sure about Galvanized...
Leave a comment:
-
Nope boat last week, home in cool this week ! Not sure beyound that someone will chime in...
Leave a comment:
-
-
-
Check and see that the slide area of the gate is not caked with dust preventing full closure
- 1 like
Leave a comment:
-
-
-
Ron I connect mine with metal hvac tape no need to glue . This matters In the event you need to move or change it. As to distance i am not sure this will.matter...
Leave a comment:
-
Once you know size you can order from mcmaster- carr https://www.mcmaster.com/zerk-grease-fittings/
Leave a comment:
-
-
-
gout, arthitis, dibetes bad joints but no tremors yet, you are in my prayers
Leave a comment:
-
Ron I got into cnc for more health reasons than i did cnc reasons, it was safer for me. Not sure what the question is yet i can relate
Leave a comment:
No activity results to display
Show More
Leave a comment: