keithrhyde
CAMaster Owner
Last Activity: Today, 12:23 PM
Joined: 06-25-2016
Location: Winchester, Virginia
-
Craig, how long average does it take to do these very nice plaques? How many do you do in a day and what is a day in your world? Great work, kudos.... -
You have a dead short somewhere in the X Drive path. Unfortunately they don't supply a electrical schematic so it is back to old school. Disconnect everything...Leave a comment:
-
Ron, did you try using the bed as Z0? It is a long shot but easy to do. If this is a new machine then Camaster needs to fix, get them to fly someone to...Leave a comment:
-
Jim, thanks, I did not think about the dust boot bristles on some machine since I take mine off after cutting. I knew I was missing something....Leave a comment:
-
Pete, there is a plate that go underneath the rails with a hole in the center for a bolt to go through and screw into the bottom of the head and tail...Leave a comment:
-
I didn't even consider leaving a bit installed when not using that is an accident waiting to happen IMHO. If you are in the habit of leaving them installed...Leave a comment:
-
Pete, this is of my Stinger 1 little smaller than yours but should be basically the same, yours would be longer. The head and tail stocks just clamp down...You do not have permission to view this gallery.
This gallery has 1 photos.Leave a comment:
-
Would someone please tell me the difference between slowly manually lowering the spindle to a wood or styrofoam block vs slowly on its own lowering to...Leave a comment:
-
Same here, my compressor is on 24/7/365 and I only shut down to make line changes in the shop or additions. Without air the spindle may drop to the spoilboard...Last edited by keithrhyde; 10-09-2021, 11:20 AM.Leave a comment:
-
Blair, now that you know Camaster has an hourly charge why not call and get their expertise which will take five minutes and it will be correct with no...Leave a comment:
-
Correct, wood only.Leave a comment:
-
Randall, great video. I have a dust collector and vacuum system both running at the same time so any spark could be a large fire very quickly. I also...Leave a comment:
-
I would think that most folks have an idea for their sign but rely on the sign maker to design but I am pragmatic and either send an email or call for...Leave a comment:
-
I use 3 flute and 1/2 inch shank bits when I can because they make less noise and cut faster and cleaner. I like the coated bits which seem to last longer...Last edited by keithrhyde; 10-08-2021, 12:32 PM.Leave a comment:
-
I have a heat and smoke detector in my basement and I have never set them off...............yet. ???? I have had some small smoke events but nothing ...Leave a comment:
-
You can have the best tool in the world but if you don't have experience you still will not get good results. A person with experience will compensate...Leave a comment:
-
I would use a cam style closer to facilitate opening and closing rather than a knob. FWIW.Leave a comment:
-
Les, mea culpa. The correct number is 540-545-4047............old age :-( If we had signature blocks as we did before the "upgrade" I would...Leave a comment:
-
Mea culpa Arlington. Now I am curious, how did you snap the wire to your XY laser? Mine is hard wired into the XY laser itself and sealed with epoxy....Leave a comment:
-
I have to go to my shop now so call me at 540-545-4547 if you are still having issues. Leave a message if I don't answer because I screen my calls and...Leave a comment:
No activity results to display
Leave a comment: