sakle2k
CAMaster Owner
Last Activity: Yesterday, 07:33 PM
Joined: 02-28-2018
Location: Central NJ
-
I was wondering why signatures with the users equipment list weren't being displayed and found that it's a setting that needs to be enabled (at least... -
Studio417, I'm not sure how you're going about it but I didn't get that kind of cut estimate when I tried it. I'm sure I must be just setting up the toolpaths...Leave a comment:
-
Thanks for the suggestions TR. I removed a V Bit that I used for one of the tool paths and that alone actually made a difference, but there was still...Leave a comment:
-
Hey TR. That's what I originally did but couldn't get the tool paths in VCarve Pro to clean up properly - the bits would not get into the smaller areas...Last edited by sakle2k; 07-05-2021, 05:07 PM.Leave a comment:
-
I finally had some time to play around with it and I was able to clean it up much better than I was able to in my Vectric model. Is using a 3D model for...Leave a comment:
-
I just sent it via PM. Thanks again!...Leave a comment:
-
Sure I'd appreciate it. Thanks!Leave a comment:
-
Yes I know I can cut a 3D file, but I can't create one. I have a pocket toolpath which includes 4 clearing toolpaths using progressively smaller tools...Last edited by sakle2k; 06-30-2021, 01:11 PM.Leave a comment:
-
Not sure what that means for me. I have VCarve Pro, not Aspire and although I'd love to speed it up, I can't create 3D files. The issue I'm having is...Leave a comment:
-
Yes, I'm looking to have the letters above the surface so everything else pocketed....Leave a comment:
-
I haven't tried cutting yet, I'm basing this off the preview in VCarve Pro. My plan was to also use WD-40 when I do cut it....Leave a comment:
-
I've attached the file.
Thanks....Leave a comment:
-
Tool path question
A friend asked if I could make some small aluminum relief "tags" for his toolboxes. Each will be 10"L x 1"H x .25"T. Every tool...
No activity results to display
Leave a comment: