Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
Thanks. I've been sick for a week, but I'll give that a try as soon as I'm feeling better.
-
Lathe is on factory mounts so I have to think it's where its supposed to be. I'm guessing that travel distance is then set in wincnc...Last edited by Ron Hampe; 05-01-2022, 10:45 AM.
Leave a comment:
-
I bought it used a while ago but this is the first time I've run it.
No messages on WinCnc
More like slamming into the end frame
No...
Leave a comment:
-
X & Y travel not working properly
The X travel is stopping approximately 3" before it reaches the center of the ornamental lathe on my SR48. What can I do to correct this?
Also...
No activity results to display
Show More
Leave a comment: