Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
The computer in my shop is primarily used for running the machine and WinCNC. Occasionally I will open a project to make changes but, I do most of the...
-
I don't know much about Blender. I do know that they have a free version and another version or offer add-ons that are not free. It may do the job but...Last edited by SteveNelson46; 11-20-2023, 06:31 PM.
Leave a comment:
-
Rhino is a full 3D modeling program and Corel Draw is mostly used for drawing. Also, Corel Draw will not generate gcode. Rhino will generate gcode with...Last edited by SteveNelson46; 11-20-2023, 01:27 PM.
Leave a comment:
-
If you are using Aspire or V-carve pro, check the Z gap above material setting. It's the setting from the tip of the bit to the top of the material. If...Last edited by SteveNelson46; 11-12-2023, 07:24 PM.
- 1 like
Leave a comment:
-
The 1 tb M.2 drive was relatively inexpensive and the motherboard was capable of handling it so I figured that, since I had the computer opened up, I...Last edited by SteveNelson46; 11-11-2023, 02:06 PM.
Leave a comment:
-
Computer upgrade
I just upgraded my Camaster shop computer to 12gb of memory and a 1 terabyte M.2 HD. I used Acronis to clone the old disk to the new and everything went...
No activity results to display
Show More
Leave a comment: