Logan Y
CAMaster Owner
Last Activity: Yesterday, 04:45 PM
Joined: 03-31-2019
Location: Kansas
-
In case anyone is interested the upgrade cost on the Vcarve side is $175 if going from 10.5 to 11. I haven't made the jump yet but I may at some point... -
I doubt anyone has tried to do it honestly. The few of us that cut metal cut mostly non-ferrous stuff and nothing super thick. I'm not saying it can't...Leave a comment:
-
I use 1/4 and 3/8 depending on the inside corner side on the shapes I'm cutting. If I don't have any inside corners or any that are small enough to worry... -
Thanks so much for the advice, makes sense. Do you use 1/4" bits on cutting out shapes? I thought 1/8" was the best but does it depend on... -
The separating board is just a bad batch. I have a feeling we may see more of this with the wood shortages and people trying to cut corners to produce...Leave a comment:
-
You don't lube the black block. At the bottom of the z-axis screw there may or may not be a block that has a zerk on it. Some models don't have that....Leave a comment:
-
Here are the requirements from the WinCNC website. They also sell preconfigured machines. If you don't want to mess with putting one together yourself...Leave a comment:
-
That's one of the main reasons I park my machine before j turn it off every time. The park macro removes the tool so it's ready to initialize next ti...Leave a comment:
-
Reset your emergency stop button a couple of times to make sure the machine is back on as needed. Power everything off then back on again. If you need...Leave a comment:
No activity results to display
Leave a comment: