Pete marken
CAMaster Owner
Last Activity: Yesterday, 08:47 PM
Joined: 04-14-2020
Location: Calera Alabama
-
The Foredom is by far the better choice. -
I had the same issue with my SR 44. I had to machine off about 1/8" from the plenum to get all the paint off before I could glue down my spoil boards....Leave a comment:
-
Are you getting power to the VFD? Circuit breaker tripped or blown fuse? Power connector on the spindle tight? Control signal connectors Tight? Are there...Leave a comment:
-
Are you getting power to the VFD? Circuit breaker tripped? Power connector on the spindle tight? Control signal connectors Tight? Are there any lights...Leave a comment:
-
Pete, Forgot to attach the TAP file they sent. I probably won't use it since I don't have a 1-1/2" bit. Will make my own tool path with a 2"...Leave a comment:
-
Pete, Here is a copy, There are also some videos on Utube most are not very applicable to CAMaster....Leave a comment:
-
Tech support sent me a procedure to align also found a couple videos. Ordered a tram indicator today. both x and Y are out.Leave a comment:
-
Thanks for the input guys. Found out today that spindle tramming in both x and y are out. Will have to fix this first.Leave a comment:
-
Z out of tram
Surfaced the spoil board today and found my Z is a little over .003 deeper towards the front of the machine, see picture. you can feel with your hand....Last edited by Pete marken; 09-09-2021, 12:28 PM. -
Double Sided Machining
Have any of you had success with a large double sided project maybe 4 ft. X 4ft. I plan on using 4 index pins and need the partial through cuts to match... -
Sounds like you have a bad air cylinder. If you gave air leaking around the cylinder rod the gland seal is bad. The cylinders used are not repairable...Leave a comment:
-
I have not had much luck with Chinese 3 hp spindles on other machines I had. On one machine I went through 3 spindles in 6 months form a CNC supplier...Leave a comment:
-
With power off I would check all the terminal connections in the control box. A slightly loose or partially corroded connection will drive you nuts. With...Leave a comment:
-
Mick,
The feed rate calculator download is right on their home page Scroll down a little. US Router Tools - Pride In Every Cut!Leave a comment:
No activity results to display
Leave a comment: