Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
I think Mick's utility is great but I also think that a new Camaster machine owner should be able to surface their spoilboard by creating a simple pocketing...
-
I don't run the laser a lot so it's handy to have a checklist.
Here's my cheat sheet for the laser setup/shutdown.
Laser Setup:...
Leave a comment:
-
I like that - very visible and easy to read.
I have something similar posted next to my machine...
Job Setup Checklist for FTC job...
Leave a comment:
-
I cut acrylic almost exclusively with no problems... but I use vacuum. I agree it would be a real pain without vacuum hold down....
Leave a comment:
-
I've made a couple of edge-lit acrylic signs - it's pretty simple and I've shown a few of the ones I've made below.
Thinner acrylic works but I...
Leave a comment:
-
I don't know much about F360 but you may want to carefully examine that curve to see how it's modeled.
Maybe in F360 model the curve using a Bezier...
Leave a comment:
-
Yes, most small hobby laser rigs use a USB interface. I just finished a laser job on my Stinger1 that a friend's Ortur laser wiith Lightburn could not...Last edited by gtgmarine; 01-09-2023, 05:32 PM.
Leave a comment:
-
Probably cheaper and easier to get a new PC to drive the lasers....
Leave a comment:
No activity results to display
Show More
Leave a comment: