CAMheads CNC Router Forum By: CAMaster CNC

CAMheads CNC Router Forum By: CAMaster CNC (http://www.camheads.org/index.php)
-   CAMheads Show Room (http://www.camheads.org/forumdisplay.php?f=4)
-   -   Twister Candle Holder (http://www.camheads.org/showthread.php?t=9896)

SteveNelson46 05-05-2019 02:49 PM

Twister Candle Holder
 
2 Attachment(s)
I made a set of candle holders awhile back when I had a Carvewright. The challenge was to make a set on my new machine. This one is a lot smaller and only has two twists. I started off with a 12" 4 by 4 Douglas Fir fence post and rounded the blank to 1.5" in diameter. The base is 3" in diameter and carved separately. It's assembled with a round mortise and tenon. A right twist for a matched set is next.

drummerjg 05-05-2019 05:31 PM

That is some beautiful work, Steve!

Mick Martin 05-08-2019 12:10 AM

1 Attachment(s)
Nice work Steve, a few years ago I was playing around with a 4 start hollow barley twist using a 4x4 from Home Depot.


All times are GMT -4. The time now is 11:23 PM.

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.