CAMheads CNC Router Forum By: CAMaster CNC

CAMheads CNC Router Forum By: CAMaster CNC (
-   CAMheads Show Room (
-   -   Twister Candle Holder (

SteveNelson46 05-05-2019 01:49 PM

Twister Candle Holder
2 Attachment(s)
I made a set of candle holders awhile back when I had a Carvewright. The challenge was to make a set on my new machine. This one is a lot smaller and only has two twists. I started off with a 12" 4 by 4 Douglas Fir fence post and rounded the blank to 1.5" in diameter. The base is 3" in diameter and carved separately. It's assembled with a round mortise and tenon. A right twist for a matched set is next.

drummerjg 05-05-2019 04:31 PM

That is some beautiful work, Steve!

Mick Martin 05-07-2019 11:10 PM

1 Attachment(s)
Nice work Steve, a few years ago I was playing around with a 4 start hollow barley twist using a 4x4 from Home Depot.

All times are GMT -4. The time now is 11:31 AM.

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.