Thread: Final setup.
View Single Post
  #13  
Old 07-05-2019, 08:30 PM
JIMMYR1RIDER JIMMYR1RIDER is offline
CAMaster Owner
 
Join Date: Jan 2017
Posts: 44
Default

Quote:
Originally Posted by Brian O View Post
Just curious why do you guys worry about the spindle dropping to the spoil board when the power is shut off? If it's because your have a small fragile bit in the spindle that might be a good reason.

I was worried in case I lost power in the middle of a carving and having a bit gouge the project then snap myself. Glad to hear that wont be happening.
Reply With Quote