View Single Post
  #3  
Old 09-07-2019, 08:56 PM
sgodding sgodding is offline
Camaster Owner
 
Join Date: Sep 2013
Location: Henryville, PA
Posts: 451
Default

Add a very short horizontal vector at the start of the profile and move the rail by the length of that vector. Recalculate the toolpath. This should force the bit to the bottom of the profile at the start. You're essentially manually adding the offset just to one side of the profile. I do this all the time for MDF door profiles.
__________________
Steve Godding
D&S Artistic Woodworking LLC
Reply With Quote