Thread: V-Carve Pro 9.5
View Single Post
  #1  
Old 08-07-2019, 11:35 AM
DLetendre DLetendre is offline
CAMaster Owner
 
Join Date: Jul 2019
Posts: 2
Default V-Carve Pro 9.5

Hello out there!
I am new to the forum and I am impressed with the information available to the users. I have a Cobra Elite on order and should get it soon.
I am am a new user to V-Carve Pro and I am trying to figure out how do cut my stair stringers out the way that I displayed them on the PDF attached. The larger portion of the stock is going to be my dedicated spoil board at .72 thickness. The stringers that are in the middle of the 5'X10' sheet are 1 1/2" thick. I also have a offset shape inside the profile of the stringers that I want to cut a 1/4" wide groove 1/8" deep or so to be able to apply some closed cell foam in to be able to lay the 2X12 pieces onto to get good vacuum. Do I have to mill the sheet first at .72 thickness and then toolpath the 2X12 profiles? I am not sure how to do this. I would appreciate any input on this.
Thanks in advance!
Dennis Letendre
Attached Files
File Type: pdf dletend_Stair_Stringers_V-Carve_Pro.pdf (17.0 KB, 51 views)
Reply With Quote