CAMheads CNC Router Forum By: CAMaster CNC

Go Back   CAMheads CNC Router Forum By: CAMaster CNC > How To Use This Forum > CAMheads How 2

Reply
 
Thread Tools Display Modes
  #1  
Old 05-17-2020, 04:18 PM
Trout Tamer Trout Tamer is offline
CAMaster Owner
 
Join Date: Jan 2015
Location: Nederland, Texas
Posts: 126
Default Surfacing new spoilboard

Finally needed to replace the spoilboard. So I milled off the remnants of the old one, cleaned everything up and glued down another 4X8 sheet of ULDF. Then initialized machine, calibrated the switch, measured the tool, and tried to run my surfacing program, which I got from Mick Martin numerous years ago, and the spindle goes to the starting point, drops down to Z0, and cuts out on -Z boundary. Okay, I figure I screwed up, so went through the whole process again, calibrating, measuring, etc. Even rebooted computer, and restarted the machine. Same results, goes to starting point, drops down to Z0, and quits. What have I forgotten?
\
Jim
__________________
Jim Meadows
Stinger III SR-48
WinCNC Aspire 8.5 Corel Draw X7
Photo V-Carve
Hurricane Vac Epilog Helix
FTC



A woman drove me to drink...
and I didn't even have the courtesy to thank her
Reply With Quote
  #2  
Old 05-17-2020, 05:39 PM
Jim Becker Jim Becker is offline
CAMaster Owner
 
Join Date: Jan 2018
Location: SE PA
Posts: 1,561
Default

When I run the utility, I have to turn of limits in order to get my spoilboard bit to the table top for the first step because it's "short". Try doing that, get the bit on the material and then start the utility.
__________________
---
Jim Becker

SR-44 (2018), 1.7kw spindle, Performance Premium, USB, Keypad, T-Slot table (y-axis configuration), WinCNC, VCarve Pro upgraded to Aspire

Non CNC stuff...

SCM/Minimax - slider/JP/BS
Festool "a good collection"
Stubby - lathe
Oneida Cyclone
more...

Retired from full time work in the telecom industry 9/2017
Commission work for equestrian tack storage and other custom furniture and cabinetry
Located Bucks County PA
http://bvww.us
bvww.etsy.com
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 03:50 PM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.