![]() |
#1
|
|||
|
|||
![]()
Just a short clip of my first experiance cutting 1/8" 6061 Aluminum. Using a 1/8" Spiral O bit from Amana.
__________________
George ______________________ CAMaster Stinger 1 FTC Porter Cable 3.25 HP with counter balance Laser Pointer WinCNC Aspire PhotoVCarve Last edited by JustWood; 06-08-2013 at 09:36 PM. |
#2
|
|||
|
|||
![]()
George,
Your clip did not make in your post. Have a 6061 aluminum project for a friend I am about ready to start so interested your first experience.
__________________
Chris Albright Stinger SR23, Porter Cable 2.25 hp Vacuum Table Z-Plate / Laser WinCNC Aspire 8.5 |
#3
|
|||
|
|||
![]()
Chris, you don't see the Youtube clip in my post? I see it.
__________________
George ______________________ CAMaster Stinger 1 FTC Porter Cable 3.25 HP with counter balance Laser Pointer WinCNC Aspire PhotoVCarve |
#4
|
|||
|
|||
![]()
Does a great job!
What were the feeds and speeds? Thanks!
__________________
Terry Williams Cobra 510 with Recoil |
#5
|
|||
|
|||
![]()
George, don't see it. Currently out of the country and viewing on a tablet (might be the problem). I will check it out when I get home. Thanks for follow up
__________________
Chris Albright Stinger SR23, Porter Cable 2.25 hp Vacuum Table Z-Plate / Laser WinCNC Aspire 8.5 |
#6
|
|||
|
|||
![]()
It is impressive how fast it cuts the 6061 but as a machinist, I think you would get a much nicer finish if you set the cutter another ½” up into the collet, and halved the feed rate.
__________________
Bruce Page Retired Hobbyist 2013 Stinger 1 SR23 FTC Laser Pointer HSD 1.7kw Spindle KRS USB Keypad Mick Martin Table Aspire 10, WinCNC Chips-a-flyin’ brucep128@gmail.com |
#7
|
|||
|
|||
![]() Quote:
Pass Depth: .0313 Feed Rate: 100 Step Over: .05 Spindle Speed: 21000
__________________
George ______________________ CAMaster Stinger 1 FTC Porter Cable 3.25 HP with counter balance Laser Pointer WinCNC Aspire PhotoVCarve |
#8
|
|||
|
|||
![]()
Thanks for the info, I just got a few pieces of 1/4" aluminum scrap (3' x 4') and have been waiting for an opportunity to do something with it.
__________________
Terry Williams Cobra 510 with Recoil |
#9
|
|||
|
|||
![]()
cant see video either
|
#10
|
|||
|
|||
![]()
This post is from 2013. The video is probably long gone
__________________
4'x8' Stinger IV w/ 4.2 hp spindle and 4 tool ATC Mister system Phenolic Vac table Hurricane Vac Vcarve Pro 10 Catholic school IT director, wannabe woodworker, Krav Maga instructor, and CNC enthusiast |
![]() |
Thread Tools | |
Display Modes | |
|
|