![]() |
#1
|
|||
|
|||
![]()
I’m the proud owner of a used stinger sr-34 that is probably over 5 years old.
I can’t get wincnc to communicate with the router yet. I’m only getting “abort-reset e-stop. I opened up the front enclosure to see “automation direct 230v 3ph.” Please say it ain’t so of a stinger II having 3 phase power. It’s a 2hp spindle and that would explain no power. Otherwise any help is appreciated. Sorry for the newbie style post. I’ve been to Vectric training and thought I was stepping up with a camaster for my first machine and hope I don’t regret not confirming a smaller router with 3 phase requirements. Andrew B |
#2
|
|||
|
|||
![]()
Best thing is for you to contact CAMaster tech support and see if you can figure out if it's really 3 phase or single phase.
As for the "abort reset e-stop", try twisting the red e-stop buttom on the side of the control box until it pops out. It may have gotten pushed in in moving.
__________________
Wes Elite CNC Routing & Woodworks on Facebook Steel 5X10 Panther 5Hp ATC spindle with 8 tool carousel WinCNC VcarvePro 9.5 15Hp FPZ vacuum, phenolic plenum |
#3
|
|||
|
|||
![]()
I agree with you.
Moderators you can delete this thread. I’ve had 3 phase confirmed, which is a new hurdle. Excited to get going, now with a VFD. |
#4
|
|||
|
|||
![]()
Um..m the spindles are 3 phase. (except for the one tiny 1.0kw option) That's how they work. But the power requirement from the wall is single phase unless you have a really big machine that has horsepower that requires industrial 3 phase power. The Stinger series use 4 wire 240v circuits from the wall when equipped with the size spindles they support. The VFD converts the single phase power to 3 phase to power the spindle. The rest of the controller is running on 120v power which is why a four wire circuit is required. Ask Camaster for the prep guide for your machine and spindle size.
__________________
--- Jim Becker SR-44 (2018), 1.7kw spindle, Performance Premium, USB, Keypad, T-Slot table (y-axis configuration), WinCNC, VCarve Pro upgraded to Aspire Non CNC stuff... SCM/Minimax - slider/JP/BS Festool "a good collection" Stubby - lathe Oneida Cyclone more... Retired from full time work in the telecom industry 9/2017 Commission work for equestrian tack storage and other custom furniture and cabinetry Located Bucks County PA |
#5
|
|||
|
|||
![]()
Yes, single phase into the frequency drive and the drive outputs 3 phase to the spindle. I always think that is cool magic.
![]()
__________________
Charlie L Stinger II, 48 by 48, 1.7 kW Spindle, FTC + Laser + Recoil + Vacuum, July 2012 WinCNC 2.5.03, Aspire 9, PhotoVCarve, Windows 7 Pro SP1 |
![]() |
Thread Tools | |
Display Modes | |
|
|