![]() |
#1
|
|||
|
|||
![]()
I have a wincnc probe that was used once for an outline of a part that I have no use for anymore, if anyone needs a replacment. If you are adding it to your machine, you may need wincnc or camaster to enable the function and assist.
Drag knife sold k_dcabinets@yahoo.com is the best way to reach me. I can take paypal, or if anyone is near houston that wants them, you are welcome to swing by. Ken Last edited by Ken Rychlik; 01-05-2021 at 02:44 PM. |
#2
|
|||
|
|||
![]()
ill take that drag knife if its still available
![]()
__________________
Stinger III 4x8
www.skaldllc.com *updating* celtfitness@gmail.com support@skaldllc.com *updating* |
#3
|
|||
|
|||
![]()
I sent you an email, if your link works
__________________
Fixing machines and making sawdust. SW side of Houston |
#4
|
|||
|
|||
![]()
it should. I will check this evening. I'm at work and wont be able to do much until then.
__________________
Stinger III 4x8
www.skaldllc.com *updating* celtfitness@gmail.com support@skaldllc.com *updating* |
#5
|
|||
|
|||
![]()
Drag knife sold. I still have the probe available
__________________
Fixing machines and making sawdust. SW side of Houston Last edited by Ken Rychlik; 01-05-2021 at 02:44 PM. |
![]() |
Thread Tools | |
Display Modes | |
|
|